Under Floor Heating Mat – 5m2 area coverage

(1 customer review)


Under Floor Heating Mat – 5m2 area coverage.  1kw power heater

These DIY heating mats are extremely easy to install. Thanks to our step-by-step video guide, anyone is able to do their installation as a DIY.

6 in stock


Under Floor Heating Mat – 5m2 area coverage

For sale !!

Under Floor Heating Mat – 5m2 area coverage ( 9 M x 0,5 M )


Instructions to fit mesh mat Under Floor Heating Mat – 5m2 area coverage

Step 1: Firsly make sure the size mat you purchased is the correct size for your room. Now you need to plan the layout of the mat. Start doing this by sketching the room with all measurements of the mat. Also, know where you would be positioning your thermostat, as this would be the starting and end point of the mat.

Step 2: Make sure the floor surface is clean and level. If there are any rough patches, level it out with a self-levelling screed.

Step 3: Now, from the point where you would place your thermostat, roll out the mat to the desired length, then cut the mesh to twist the mat to run parallel next to the rolled-out length, be careful not to cut the wire. You may cut away some mesh if you have excess, this could happen when installing in bathrooms. Continue in this fashion until the desired floor space is covered, ending back at the starting point.

Step 4: To hold the mat in place, use strong duct tape, a hot glue gun or nails attached to the mesh, NOT the wire.

External probe or floor sensor.

Step 5: If you are installing an external sensor (which would be used for bathrooms, screed floors and wooden floors ), this should be perfectly positioned in the middle of the heating wires. If you position it closer to one cable than the other, the temperature would not be gauged properly.

Step 6: If you had purchased an alarm ( ideally you should ), connect the cold tails ( this is the wire at end of the mat which connects to the thermostat ), to the alarm to ensure the mat did not get damaged. If the alarm sounds, you have a problem.

Step 7. To lay your tiles or floor surface: There are 2 methods, it is up to your own initiative.

Method 1: You can lay tiles directly on top of the mat ensuring the tile adhesive goes through the mesh to make contact with the concrete floor.

Method 2: Prepare a slurry mixture of self-levelling screed and bonding liquid. Spread this mixture over the mat and leave it to dry. This mixture will get rock-hard. You can now install the floor surface of your choice.

Step 8. Most importantly check the alarm hasn’t sounded.

Step 9. You can now connect the temperature controller to the floor heating system.

Step 10. And lastly, let it dry for a few days before the first usage.

Under Floor Heating Mat – 5m2 area coverage

Our Underfloor Heating mesh mat is very easy to install anyone can do it as long as you know your maths you will succeed in the installation of your Underfloor Heating mesh mat if you have any Inquiries about the installation do not hesitate to reach out to us we are only one Call/Whatsapp away and we can guide you through any part of the installation.

We also have pictures and videos showing an easy step-by-step guide on how to do the installation, all in all, it is a super easy and DIY Friendly task to join in on, no rocket science needed at all with just a little bit of knowledge and planning any installation can come out a successful project and there is no dought that you will be happy with the FINAL product.

Instructions to fit mesh mat floor heating
Instructions to fit mesh mat floor heating.

If you are using the wire without the mesh, you should watch the following video link


Under Floor Heating Mat – 5m2 area coverage


Additional information

Weight1 kg
Dimensions50 × 20 × 20 cm

1 review for Under Floor Heating Mat – 5m2 area coverage

  1. jcfloorheating

    Thank you ,great deal !!!

Add a review